Lifting clamp for horizontal plates or plates CH

This clamp offers safe lifting and transportation of sheets horizontally and without damaging the surface of the sheet.

Characteristics of Lifting Clamp for Sheets or Horizontal Sheets CH

You can use them with rocker arms and it is best to use them in pairs.
It has been tested with double its recommended capacity.
It ensures the integrity of sheets with a hardness of 37 RC (345 HB).
Rotation up to 120° horizontally.

Lifting tongs for the safe transport of steel plates in a horizontal position. To lift steel sheets up to a hardness of 37 RC (345 HB).

Properties:

• The WLL and jaw opening size are clearly indicated on the clamp.
• Suitable for lifting and horizontal transportation of steel plates that do not bend.
• These clamps can also be placed under a lifting frame or chain sling.
• Always use it in pairs.
• Compact and low weight design.
• Safety factor of at least 5 x WLL.
• Each clamp has a test load of 2 x WLL.

Request:

• To lift steel plates up to a hardness of 37 RC (345 HB).
• For the safe transport of steel plates in a horizontal position.

Marking: according to standard, CE marking

Standard: EN 13155, EN 12100

Safety factor: 5